News information

Summary:

(1) Before replacing the brake fluid, the vehicle should be parked on a level road surface, and then check that the brake fluid level has reached the prescribed position. If the brake fluid volume decreases, analyze the cause and troubleshoot before replacing the new oil.

(2) First use the suction tool to pump out the oil in the brake oil storage tank and pump it to the bottom of the oil storage tank; if there is no oil suction machine, you can use the brake oil drain port of one of the four wheels to put the old oil. Put it out and put it on the oil level. No matter what kind of method, it can't be cleared up at one time for the sake of simplicity. Because the air enters the oil pump, it will be troublesome and it will even damage the brake oil pump.

(3) After putting the oil in the oil storage tank, fill up with new brake oil and put it into the brake oil storage tank. After the oil is released, check the oil level of the brake fluid of the tank from time to time, and add it almost in the end. Remember to avoid it. Air enters the brake system. This is done by using the new brake oil cleaning system and forcing out the old oil.

(4) The process of replacing the brake oil is not necessary to start the car. It definitely requires two people to do it. One is to apply the brakes and one to put the oil. The other is to charge the brakes every time. Each wheel must be done several times, one wheel at a time. Before the first step on the brakes a few times, and finally step on a hard step, and then notify the release of the oil can be discharged; Responsible for the release of the oil in the loose open screw oil release, and then tighten the drain screw, and can be informed responsible step Once the braking process is completed, if the operator does several times, the old oil in the brake oil can be completely discharged, and the entire brake system is replaced with new oil.

(5) When opening the oil drain and releasing the old brake oil, pay attention to the old brake oil to be received by the container, and do not drain or splash it to other parts to avoid other undesirable phenomena. The metal corrosion of brake oil is very strong.

(6) Put the old brake oil as clean as possible. If the old oil is dirty, apply new brake oil to inject the oil tank 1-2 times until the flushing oil comes out clean (do not flush it with other oils). .

(7) Finally, close all drain ports, open the filler port, and inject new brake fluid to the desired position.

(8) Start the vehicle to test the brakes, and then stop to check the brake oil level, if necessary, make up the appropriate amount.

(9) During the driving process, it is necessary to check the amount of brake fluid and the quality of the brake fluid from time to time. The amount of oil is insufficient to make up. It is strictly forbidden to mix different types of brake fluid. When the brake fluid deteriorates, it should be replaced to avoid accidents.

(10) The brake fluid is easily absorbed by the moisture in the air, so the remaining brake fluid must be sealed and stored.